Difference between revisions of "T8S to L1 Model II"
m |
m (/* {{Model II}} Analog Input formatting) |
||
| Line 14: | Line 14: | ||
{{#lst:L1® Model II|AnalogInput}} | {{#lst:L1® Model II|AnalogInput}} | ||
--> | --> | ||
| + | |||
| + | == Gain Staging == | ||
| + | For each {{Model II}} | ||
=== {{Model II}} Analog Input === | === {{Model II}} Analog Input === | ||
Revision as of 10:41, 14 July 2018
Contents
Connect the T8S to L1 Model II
Use 1/4 inch (6 mm) Tip-Ring-Sleeve cables.
Connect the ToneMatch Power Supply to the T8S ToneMatch mixer for power.
Set the L1 Model II Analog Input Trims to about 9:00 o'clock.
Gain Staging
For each L1 Model II
L1 Model II Analog Input
The Analog input is a ¼ inch balanced input jack.
Analog input trim (volume, or gain) control
There is a trim control for the analog input.
- Set the Trim control on the power stand to the 0 (zero) position.
- Connect the T8S ToneMatch mixer Main Output to the Analog Input
- Adjust the volume of the T8S ToneMatch mixer Main Output to the maximum output without distortion. This is probably between 10:00 o'clock and 12:00 o'clock on the Master Output
- While playing the source, increase the Trim level so that the Signal/Clip indicator glows green or yellow. This will probably be around 9:00-11:00 o'clock
- If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.
