Difference between revisions of "T1 ToneMatch® Audio Engine to Compact"
m |
m |
||
| Line 1: | Line 1: | ||
| − | You can connect a {{T1}} to {{Compact}} | + | <includeonly>You can connect a {{T1}} to {{Compact}} |
| + | </includeonly> | ||
| − | + | Here is an excert from page 12 of the {{Compact Owners Guide}} | |
| − | |||
[[Image:CompactOwnersGuideT1Connection.gif]] | [[Image:CompactOwnersGuideT1Connection.gif]] | ||
Revision as of 10:52, 21 August 2011
Here is an excert from page 12 of the L1® Compact Owner's Guide (pdf format)
Connect FROM T1 ToneMatch Audio Engine Master or Aux Output using ¼ inch jack connections.
Connect TO the Compact Channel 2 volume straight up (12:00 o'clock to 1:00 o'clock) for good results. You can turn it up higher, but if you see the light on the Compact flickering red, turn down the volume on the Compact.
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)
A balanced connection is preferred and will provide better noise rejection over greater distances than the unbalanced connection.
¼ Inch Tip-Ring-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)
This should work fine but a balanced connection (immediately above) is preferred especially if you will have cable runs in excess of 20 feet (6 meters) or if you hear line noise, hum or hiss.
Channel 2 Connection from T1 ToneMatch Audio Engine Details
For more general information see: T1 ToneMatch Audio Engine and L1 Compact