Difference between revisions of "Mixer / Yamaha / MG124 CX"
m (→¼ inch jack inch to ¼ inch) |
m |
||
| Line 1: | Line 1: | ||
To use a Yamaha MG124 CX Mixer with the {{Model II}} | To use a Yamaha MG124 CX Mixer with the {{Model II}} | ||
| − | + | ==== Overview ==== | |
On the mixer | On the mixer | ||
* pan all the inputs hard LEFT | * pan all the inputs hard LEFT | ||
Revision as of 11:48, 19 September 2012
To use a Yamaha MG124 CX Mixer with the L1 Model II
Contents
Overview
On the mixer
- pan all the inputs hard LEFT
- run a line out of the LEFT output to the Model II Power Stand Analog input (cable details below)
Cable Details
¼ inch jack inch to ¼ inch
|
This mixer has ¼ inch jack balanced outputs. Any of the cables shown below should work.
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)The output of this mixer is balanced, and the input on the Model II Power Stand is also balanced, so this is the preferred method.
¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced)
|
