Difference between revisions of "Template:L1 Model II Analog Input Gain Staging Device"
(Created page with " === {{Model II}} Analog Input === The Analog input is a ¼ inch balanced input jack. Image:Model 1S Analog Input Detail.png ==== Analog input trim (volume, or gain)...") |
m (→Analog input trim (volume, or gain) control) |
||
Line 14: | Line 14: | ||
# Set the '''Trim''' control on the power stand to the 0 (zero) position. | # Set the '''Trim''' control on the power stand to the 0 (zero) position. | ||
# Connect the {{{Device|source device}}} Main Output to the Analog Input | # Connect the {{{Device|source device}}} Main Output to the Analog Input | ||
− | # Adjust the volume of the {{{Device|source device}}} Main Output to the maximum output without distortion. | + | # Adjust the volume of the {{{Device|source device}}} Main Output to the maximum output without distortion. |
+ | #* On analog consoles this may be marked as '''unity''' or '''0 dB'''. | ||
+ | #* On digital consoles this may be marked as '''-18 dBFS<ref>[https://en.wikipedia.org/wiki/DBFS dBFS]</ref>'''. The exact value may vary depending your location. | ||
# While playing the source, increase the '''Trim''' level so that the '''Signal/Clip''' indicator glows green or yellow. This will probably be around 9:00-11:00 o'clock | # While playing the source, increase the '''Trim''' level so that the '''Signal/Clip''' indicator glows green or yellow. This will probably be around 9:00-11:00 o'clock | ||
# If the '''Signal/Clip''' indicator glows red, decrease the '''Trim''' level so that it glows only green or yellow. | # If the '''Signal/Clip''' indicator glows red, decrease the '''Trim''' level so that it glows only green or yellow. |
Revision as of 10:23, 8 April 2019
L1 Model II Analog Input
The Analog input is a ¼ inch balanced input jack.
Analog input trim (volume, or gain) control
Setting the trim level on the Model II Power Stand is a one-time step. Once you have matched the output of the ToneMatch mixer to the input of the L1 you don't need to adjust it again.
- Set the Trim control on the power stand to the 0 (zero) position.
- Connect the source device Main Output to the Analog Input
- Adjust the volume of the source device Main Output to the maximum output without distortion.
- On analog consoles this may be marked as unity or 0 dB.
- On digital consoles this may be marked as -18 dBFS[1]. The exact value may vary depending your location.
- While playing the source, increase the Trim level so that the Signal/Clip indicator glows green or yellow. This will probably be around 9:00-11:00 o'clock
- If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.