Rubber Feet for L1®

From Bose Portable PA Encyclopedia
Revision as of 07:13, 23 June 2016 by ST (talk | contribs) (New page: <html> I removed a nearly new foot from a Model II. The measurements are as follows:<br>Diameter 1-3/16" X height 3/8" (30mm X 9.6mm)<br><br> The maximum height of 3/8" (9.6mm) for the fe...)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

I removed a nearly new foot from a Model II. The measurements are as follows:
Diameter 1-3/16" X height 3/8" (30mm X 9.6mm)

The maximum height of 3/8" (9.6mm) for the feet is important for stability; it is not recommended to use thicker feet because the ends of the fold out legs would be raised off of the floor

The recesses where the feet are installed will not accept a larger diameter than the original feet but 1" (25.4mm) should work fine.

I did a bit of research for you for some possible replacement feet:

Penn Elcom F1690

Keystone Electronics 723 DigiKey

MojoTone Rubber Feet, 25.4X9.5mm

This type of feet are commonly used under guitar amp cabinets, it's a matter of finding some of the correct height and of a diameter that will fit. These need to have a steel washer for the mounting screw.

This should help you find suitable replacement feet.



Mark

Source: Le5 Rubber Feet for L1®

Retrieved from "https://toonz.ca/bose/wiki/index.php?title=Rubber_Feet_for_L1®&oldid=17717"