S1 Pro+ To L1 Pro

S1 Pro+  

L1 Pro

S1 Pro+ to L1 Pro

Connect an S1 Pro+ to an L1 Pro

The objective is to use the S1 Pro+ as the stage monitor facing the performer(s) and the L1 Pro will be the main loudspeaker for the audience; the Front of House system (FOH).

You will connect your microphone and or instruments to the S1 Pro+

Terms used

S1 Pro+ (stage monitor and mixer)

This is the S1 Pro+ to which you have connected your microphone and or instruments using inputs 1, 2, 3

L1 Pro (main loudspeaker for the audience - Front of House)

This is the L1 Pro to which you send the sound from S1 Pro+

Set Up

1. S1 Pro+ Turn down the volume on all channels.
2. L1 Pro
   • Turn down the volume on all channels.
   • Set Bass and Treble at 12:00 o'clock (flat)
   • Set Reverb off (see alternate connection below)
   • Set ToneMatch to Off

XLR Cable

Use an XLR cable (e.g., microphone cable) to connect the S1 Pro+ Line Out to L1 Pro channel 1 or 2.

• The advantage to this method is XLR cables are common and easily found
• The disadvantage is you takes up a full-featured channel on the L1 Pro

XLR to 1/4 inch (6.3 mm) Tip-Ring-Sleeve

Use an XLR to 1/4 inch (6.3 mm) Tip-Ring-Sleeve cable

• The advantage to this method is this leaves both full-featured channels (1 & 2) on the L1 Pro available for other uses

or use an XLR cable with a converter

Levels

1. On S1 Pro+, bring up the channel volumes to the desired levels
2. On L1 Pro, bring up the channel volume to suit your application. Note: This will not necessarily match the same position on the dials as S1 Pro+
3. Turn down the volume on any unused channels

---