T1 ToneMatch® Audio Engine / Mono Output to Two L1®s
ApplicationThis article will primarily be of interest to DJs. It is NOT recommended that you do this for typical live music applications. For reasons why see Dual Mono. NOTE: If you run two L1®s in Dual Mono mode, the L1®s should be at least 20-50 feet apart. |
You can route a signal through a single T1 ToneMatch Audio Engine out to two L1 s.
One L1® Model II and any other kind of L1®
If one of the L1®s is L1 Model II then this is very simple. Run the ToneMatch® Cable to the Model II, and use a ¼ inch jack cable from the Analog Master output to the other L1®. The rest of this article is not applicable for you.
Two L1®s L1 Classic or L1 Model I
If you do not have a L1 Model II then you use
- a ¼ inch jack cable from the Analog Master Output to one L1®, and
- a ¼ inch jack cable from the Analog Aux Output to the other L1®
Sending a Channel Output to Aux
You MUST set up up the Aux output for each Channel that you want to send to both L1®s.
Turn the Rotary Selector to Aux
Press Tap to set the tap point
Set the Tap to Post: After Fader
Turn the Level to 100% to start. You will adjust this later.
Now you can use the Aux Level (shown as 100%) to balance the output between the Aux output and Master Output