Mixer / Yamaha / MG124 CX

To use a Yamaha MG124 CX Mixer with the L1 Model II

On the mixer

• pan all the inputs hard LEFT
• run a line out of the LEFT output to the Model II Power Stand Analog input (cable details below)

¼ inch jack inch to ¼ inch

This mixer has ¼ inch jack balanced outputs. Any of the cables shown below should work.

¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced) ¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced) ¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced) This should also work, but likely no better than a simple ¼ Inch Tip-Sleeve to Tip-Sleeve cable. This is because the ¼ Inch input on the Bose System is Tip-Sleeve (unbalanced) anyway.

---