Template:T1 ToneMatch® Audio Engine to Two L1®s

Usage:

{{Two T1®s with Two L1®s
|Model=Model II
}}

Please note: Bose recommends that if you have two Model 1S systems using the same source, that you place the Model 1S systems at least 20 feet apart (6 meters). This is to avoid Multiple Source Interference

Running two Model 1S systems with the same source is running Dual Mono and not recommended unless the L1®s are at least 20 feet apart.

System 1 Connect the first system with the ToneMatch cable that came with the T1®. T1® ToneMatch port to the Model 1S Power Stand ToneMatch port.

System 2 Connect the second system with a ¼ inch jack Tip-Ring-Sleeve cable T1® Master Output to the Model 1S Power Stand Analog input on the Model 1S Power Stand set the analog input trim to "3" and adjust as necessary to get a good balance with the other system. For best results use a Tip-Ring-Sleeve (balanced) connection. You can use a Tip-Sleeve (unbalanced connection) but the Tip-Ring-Sleeve (balanced connection is preferred).

---