Denon DN-MC6000

Suggestions for connecting the Denon DN-MC6000 Professional DJ Multi-controller to an L1® Model 1S, Model II, or Compact.

See the diagram below (from Denon DN-MC6000 Professional DJ Multi-controller manual: Page 10)

Running mono, set the output to MONO above and connect to the Model II Analog input or Model 1S Analog input or Compact Channel 2

[[1]]

With a cable like this:

Source: Audiopile.net

Technical Description:

The EWI MP-105 is a special application adaptor cable for converting XLR to 1/4 TRS. This cable is typically used to plug XLR cord into balanced 1/4" TRS panel jacks commonly found on mixing consoles and processing equipment.

The Female XLR end is wired through to the 1/4" Male TRS end as follows:

• Pin One FXLR to Sleeve of MTRS
• Pin Two FXLR to Tip of MTRS
• Pin Three FXLR to Ring of MTRS

The 1/4" MTRS end is an EWI model P292S-BKG

The FXLR end is an EWI model ES3FB-GDP

The cable itself is constructed with 99.98% pure 22ga. high strand count copper conductors.