TC-HeliconVoiceSolo FX150 to L1® Compact
The VoiceSolo FX150 has two outputs available (Vocal and Guitar) but I choose the LEFT output and run MONO so that I can make the connection with one cable. I don't use Compact Channel 1 when I'm using the VoiceSolo FX150.
I prefer to use an adapter (XLR to ¼ inch jack) from the VoiceSolo FX150 left out - to Compact Channel 2. That way you don't have to work around the Compact's internal microphone Preset.
There's MIX button on the VoiceSolo FX150 that brings up a screen where it's easy to control the relative volumes. Vocal volume is set. You can raise and lower the other inputs on the VoiceSolo FX150. so I don't have to touch the {{{L1}}} once I'm set up.. And it's nice to use just one cable from the VoiceSolo FX150 to the Compact. This also keeps the Compact Channel 1 free in case I need to plug in another microphone.
I use an adapter like this
| Neutrik NA3FJ XLR to ¼ inch jack Tip-Ring-Sleeve female | or | Planet Waves XLR female to ¼ inch jack Tip-Ring-Sleeve female |
|
|
|
WITH
| Balanced ¼ inch jack Tip-Ring-Sleeve cable | or | Unbalanced ¼ inch jack Tip-Sleeve cable |
|
|
|
OR a longer version of a cable like this:
Technical Description:
The EWI MP-105 is a special application adaptor cable for converting XLR to 1/4 TRS. This cable is typically used to plug XLR cord into balanced 1/4" TRS panel jacks commonly found on mixing consoles and processing equipment.
The Female XLR end is wired through to the 1/4" Male TRS end as follows:
- Pin One FXLR to Sleeve of MTRS
- Pin Two FXLR to Tip of MTRS
- Pin Three FXLR to Ring of MTRS
The 1/4" MTRS end is an EWI model P292S-BKG
The FXLR end is an EWI model ES3FB-GDP
The cable itself is constructed with 99.98% pure 22ga. high strand count copper conductors.
TO