S1 Pro to L1 Model I

From Bose Portable PA Encyclopedia
Revision as of 18:52, 19 October 2018 by ST (talk | contribs) (Created article)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

If you want to use your S1 Pro System as a monitor and use an L1 Model I as the Front of House system you can connect your microphone and instrument to the S1 Pro System and connect the S1 Pro System to the L1 Model I


How To

Connect S1 Pro System to L1 Model I

You can connect to the S1 Pro system as you would when using it alone. Then run a cable from the S1 Pro Line Out to any of the 1/4" inputs on the L1 Model I. You can use an ordinary Tip-Sleeve instrument cable.

If you use the L1 Model I inputs on channels 1 or 2, set the Preset to 00. Set the input trim so that when you are running the S1 Pro at the loudest you will perform, the L1 Model I Signal/OL lights are solid green. Occasional red flickers are okay.

Additional Information

Note: All the 1/4" inputs on the L1 Model I are unbalanced. That means, there's no need or advantage to using a balanced Tip-Ring-Sleeve cable. Also, if you use a 1/4" Tip-Ring-Sleeve to XLR cable into channels 1 or 2, you may find it difficult to do the gain staging because the signal from the S1 Pro may be too hot for the XLR inputs.


Retrieved from "https://toonz.ca/bose/wiki/index.php?title=S1_Pro_to_L1_Model_I&oldid=19976"