Template:L1 Model II Analog Input Gain Staging Device
Revision as of 22:21, 6 April 2019 by ST (talk | contribs) (Created page with " === {{Model II}} Analog Input === The Analog input is a ¼ inch balanced input jack. Image:Model 1S Analog Input Detail.png ==== Analog input trim (volume, or gain)...")
L1 Model II Analog Input
The Analog input is a ¼ inch balanced input jack.
Analog input trim (volume, or gain) control
Setting the trim level on the Model II Power Stand is a one-time step. Once you have matched the output of the ToneMatch mixer to the input of the L1 you don't need to adjust it again.
- Set the Trim control on the power stand to the 0 (zero) position.
- Connect the source device Main Output to the Analog Input
- Adjust the volume of the source device Main Output to the maximum output without distortion. This may be marked as unity or 0 dB.
- While playing the source, increase the Trim level so that the Signal/Clip indicator glows green or yellow. This will probably be around 9:00-11:00 o'clock
- If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.