S1 Pro+ Wireless Insert Mode With Modeler
This is a super convenient feature of the S1 Pro+ when using a Bose Wireless Transmitter.
In this setup, the Bose Wireless transmitters are connected to:
- XLR to Sennheiser MD 445 handheld microphone (Channel 1)
- 1/4-inch to electric guitar (Channel 2)
Close-up of 1/4-inch transmitter connected to the electric guitar
Close-up on the microphone with the XLR wireless transmitter. Later, the microphone was set up on a microphone stand.
Connections to the back of the guitar modeler.
- Red connects to the Tip-Ring-Sleeve RING connector and goes to the modeler INPUT
- Grey connects to the Tip-Ring-Sleeve Tip connector and goes to the model OUTPUT
The Tip-Ring-Sleeve to two Tip-Sleeve cable (often called an INSERT cable)
The Tip-Ring-Sleeve end of cable going to S1 Pro+ channel 2.
- When using an amp modeler pedal, for best performance, use the Bose Music app to select the Full Range Flat Response (FRFR) ToneMatch preset for that channel.
Documentation from the S1 Pro+ Owner's Guide
- Notes
- Be sure to set the S1 Pro+ channel INSERT to Auto
- In the example above, we connected the guitar to channel 2; in the documentation below, it is connected to channel 1. The principles are equally applicable.
