B1 Rotate the Logos

From Bose Portable PA Encyclopedia FAQ & Wiki
Revision as of 10:42, 8 July 2013 by ST (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

You can rotate the Bose logo so it is parallel to the floor even if you have turned the B1 on its side. Chuck-at-Bose said, "... Maybe it's my kung fu grip, but I've had good luck with carefully pinching the logo and pulling at these points, then rotating 90 degrees:"

B1LogoRotate.jpg

Be very careful with the fine ends of the logo because they can be easily broken off. You may even try to pull up in the middle with your fingernails on the edge instead of near the ends.

Go from thisto this
Rotateb101.jpg Rotateb102.jpg

Pull the logo straight out about ½ inch before you attempt to turn it. It is spring loaded, and the rear post is square. You have to clear the post (about ½ inch before you can turn it).

Rotateb103.jpg

Another look.


Rotateb104.jpg

After you rotate the logo make sure that the logo is flush with the grille so that it does not rattle when the music is playing.