Presets 3.0 Upgrade Instructions

From Bose Portable PA Encyclopedia
Revision as of 01:42, 17 December 2007 by ST (talk | contribs) (formatting)
Jump to: navigation, search

Classic This information is applicable to the L1® Classic
L1 Model I This information is applicable to the L1 Model I

Announcement

Announcement from Neil-at-Bose November 24, 2007

Attention DJ’s using the L1 Model I system,

We recently identified an isolated issue that only affects DJ’s that are using Preset #58 (High Volume Pre Recorded Music) on the L1™ model I system.

It was discovered that L1™ model I power stands with a serial number less than 042829Z72550001AC did not accurately contain the advertised preset #58. This preset is specifically intended for DJ’s playing pre recorded music at higher volume levels. Instead it contained a flat EQ setting which is identical to selecting preset 00.

If you do not intend to use this preset than there is no need to be concerned with this message. All other system presets have been verified and their contents are accurate.

To immediately correct this situation we are making an updated L1™ model I Preset version 3.0 available for download on our online forum. Again as a reminder there is no need to update your system if you do not intend on using this preset.

We would like to apologize for any inconvenience that this may have caused and take the opportunity to thank you for bringing this to our attention. Additionally we are excited that the “Just for DJ’s” forum is consistently among the most popular areas of our online community.

Thank you for your support. Original Announcement by Neil-at-Bose L1 Model I - Preset 3.0 Patch (DJ's only)


Instructions

Download

Documents

Clarification for L1™ Classic Owners

And a note from MikeZ-at-Bose

Here's the deal -
The above update WILL work for Classic owners and will give you the entire 3.0 preset list, including Preset 58.
However, this is an 'under the table' update - we can't have our phone team answering calls on it. The update follows the same well documented update process used on past Classic updates. It can be troublesome to update, that's why we have the T1 now.
I would like to stress this update ONLY updates presets and not the firmware. It has NO change on the function of the system except for the presets. If you are not going to use the extra presets then there is no reason to go through the trouble of upgrading.
-Mike