Search results

Jump to: navigation, search
  • # Using a Balanced cable from the Aux Out to the Rolls, gave signal in both ears! Nice.
    1 KB (255 words) - 04:48, 26 March 2017
  • [[Image:XLR Male to TRS.jpg|200px|TRS Male to XLR Male balanced cable]]
    248 bytes (40 words) - 15:11, 13 March 2008
  • ...nected and it will reduce the bass output level and the sound will now be "balanced".
    5 KB (774 words) - 16:10, 28 April 2023
  • * Balanced XLR audio output for Microphone or Line level signals and a 1/4-inch line l
    4 KB (614 words) - 14:24, 11 March 2020
  • I still use my Taylor for recording as it is a little more balanced when mic'd. The CA has a little more of a tinkly bell sound on the upper re
    3 KB (547 words) - 14:39, 11 March 2019
  • ...nice sustain. The low "E" strings is about as deep as they can be and very balanced with the others. The unplugged volume is about the same as the wooden count
    2 KB (301 words) - 02:59, 16 January 2009
  • ...real good but far away” VDrums “not as dynamic, could be louder, not balanced within the instrument (toms, snare, etc)”
    34 KB (6,140 words) - 03:49, 24 February 2010
  • ...Simultaneous outputs let the amp drive any combination of stereo speaker, balanced recording and slave amp outputs. The speaker outputs can handle 4 or 8 ohm
    34 KB (5,610 words) - 15:00, 18 January 2021
  • :*Convert the signal to mono and if the output is balanced, use a 1/4 inch (6.3 mm) Tip-Ring-Sleeve or XLR to 1/4 inch (6.3 mm) Tip-Ri
    4 KB (640 words) - 19:22, 20 February 2024
  • Output impedance at 1kHz (balanced) (1/2 ± 20%): 150
    2 KB (329 words) - 19:35, 21 July 2021
  • The analog input on the Model II is balanced, and will therefore subtract the Left and Right signals on a stereo cable a
    2 KB (292 words) - 19:32, 30 September 2019
  • The guitar had a strong, well-balanced sound. It was, as Jean
    15 KB (1,966 words) - 05:52, 26 March 2017
  • The Power Stand for the {{Classic}}, {{Model I}} and {{Model II}} have a balanced ¼ inch jack line out for bass expansion. See the links below for det
    1 KB (162 words) - 13:49, 28 May 2019
  • ...eMatch® Audio Engine / 1/4 inch Output Connections to L1® Family Members|Balanced}}
    1 KB (190 words) - 14:49, 14 August 2019
  • ...to perfectly fall under the string – This translates into extremely well balanced pickups without dead areas and hotspots, particularly on large string bends
    6 KB (926 words) - 18:46, 26 March 2017
  • <table><tr><td>Balanced &frac14; inch jack Tip-Ring-Sleeve cable</td><td> or </td><td>Unbalanced &f
    4 KB (655 words) - 22:53, 28 March 2017
  • ...ll with LRBaggs Element for Nylon String. The sound was immediately warm, balanced, and completely hum-free - I could play at high sound pressure levels with
    6 KB (1,079 words) - 02:22, 27 December 2014
  • {{:Balanced vs Unbalanced}}
    27 bytes (3 words) - 11:03, 19 March 2015
  • Individual outputs that provide balanced line output signals (pre-volume control) that can be sent to powered louds
    20 KB (3,211 words) - 12:46, 29 September 2023
  • ...pendent of the Master volume. This is why you want to set it to be equally balanced with the Master. You will then be able to control the balance and level fro
    5 KB (809 words) - 17:12, 26 December 2017

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)