Search results

Create the page "Powered Mixer" on this wiki! See also the search results found.

• Powered Mixers
  ==Can I use a powered mixer?== ...red mixer to any Bose Portable PA equipment including ToneMatch mixers and powered loudspeakers (L1, F1, S1 Pro)
  4 KB (664 words) - 22:22, 16 November 2019
• Power Sequence
  * Turn on the powered loudspeakers last. * Turn off the powered loudspeakers first.
  2 KB (266 words) - 12:47, 22 November 2019
• Is It Too Expensive?
  ..., I couldn't perceive a lot of value in the old stuff. (Bose 802s, powered mixer, power amps, floor wedge monitors). So I donated it all to a worthy cause. ...System has onboard amplifiers and integrated speakers. So to some, it's a powered speaker.
  16 KB (2,913 words) - 11:43, 9 May 2011
• Kemper Profiler
  ...The number of rigs in memory does only make a difference when the unit was powered off accidentally. If you use the power button or the chicken head to power == Kemper Powered Kab ==
  24 KB (3,721 words) - 12:54, 8 August 2023
• Should I get an L1 Pro16 or L1 Pro32
  ...an be controlled using the Bose Music App, and you can connect a ToneMatch mixer to the ToneMatch port. ...ong (32 drivers) and powered by 480 watts RMS. The L1 Pro16 has 16 drivers powered by 240 watts RMS.
  15 KB (2,619 words) - 15:00, 31 October 2023
• Ground Loop
  ...o the audio signal at the mixer with headphones. If the buzz exists at the mixer then do the following: ...uts or outputs are disconnected which are connected to devices that are AC powered, then it is likely caused by a ground loop.
  8 KB (1,303 words) - 09:31, 7 April 2019
• F1 Model 812 Flexible Array Loudspeaker
  ...T1}} or {{ToneMatch Mixer}}) to the maximum you can without clipping. On a mixer this may be shown as unity or 0. ==== Stereo + Mixer ====
  20 KB (3,211 words) - 12:46, 29 September 2023
• S1 Pro Line Out to a Third Party Device
  If another device (like a third-party mixer or powered loudspeaker) has a 1/4 inch (6 mm) input, and you don't know if it's balanc Many modern powered loudspeakers will accept a balanced line-level device. If you use a Tip-Rin
  3 KB (500 words) - 22:20, 16 November 2019
• Phantom Power
  What is a "phantom powered" microphone? Does that mean that the microphone draws its power from a remo ...veling down. Thus, the microphone is receiving the power remotely from the mixer.
  8 KB (1,252 words) - 19:43, 10 March 2020
• McIntyre BluesMaker II
  ...the guitarist, who demands tonal variations not found on conventional low powered amplifiers. The Bluesmaker MKII is a masterpiece of complex tone voicings w ...recording amp and direct source. When connected to a recording or PA mixer,<br>
  34 KB (5,610 words) - 15:00, 18 January 2021
• Mixer Left Output Only
  When using a mixer is some of the quality lost using just the left output? Connecting a stereo mixer to a mono {{L1}}. {{Compact}}, {{Model 1S}}, {{Model 1S}}, {{F1}}
  1 KB (198 words) - 11:48, 1 September 2018
• T4S/T8S ToneMatch® Mixer
  {{T4S/T8S ToneMatch Mixer Owners Guide}} ...://global.bose.com/en_us/product_registration.html Register your ToneMatch mixer]
  9 KB (1,484 words) - 23:55, 13 December 2023
• Multi Mono
  * Running multiple powered loudspeakers ({{L1}}, {{F1}}, {{S1}}, [[L1 Pro]] or other) * Every sound source is heard through only one powered loudspeaker
  564 bytes (86 words) - 23:24, 11 June 2021
• L1® Model I / FAQ
  ...ut are designed for 0 dB line-level signals (e.g., from an effects device, mixer or MP3 player). Use the remote control master knob as the last stage of gai In the new approach mixer, PA speakers, monitors and backline amplifiers (e.g. guitar amps) are repla
  60 KB (9,859 words) - 05:33, 26 March 2017
• L1® Compact
  High-performing, powered, portable two-way loudspeaker system with a 180° H x 40° V nominal disper == Mixer to Share Presets ==
  27 KB (4,306 words) - 01:35, 20 May 2021
• Mixer / Behringer / Europower / PMP6000
  <big>''' Behringer Eurorack PMP6000 Powered Mixer '''</big> ...PMP6000_PMP4000_PMP1000_M_EN.pdf Behringer EUROPOWER PMP6000] is a powered mixer. DO NOT CONNECT the speaker outputs to your {{Model 1S}} or {{Model II}}. Y
  2 KB (223 words) - 13:15, 28 July 2014
• Do I Need to Upgrade from the L1 Compact to the L1 Pro8?
  ...<br>This would make it easy to connect a T1 ToneMatch mixer. The ToneMatch mixer resolves all three points above. ...hat's nearly twice the surface area of the 8-inch woofer in the L1 Compact powered by 65 watts RMS. The L1 Pro8 gives a satisfying thump with PorchBoard Bass.
  5 KB (829 words) - 18:18, 30 November 2021
• L1® Model II
  ==== Using a Mixer ==== {{:L1® Model II with Mixer to Analog Input}}
  9 KB (1,440 words) - 01:37, 20 May 2021
• L1® Line Outs
  ...nd your sound out to an external system (remote speaker system, recording, powered loudspeaker) these notes are for you. To run a signal to an external monitor or powered speaker system you need to take that signal from the same source that you a
  1 KB (235 words) - 05:27, 26 March 2017
• ToneMatch Mixer Phantom Power to Tyros 5 Microphone Input
  ...yros-5?reply=40442221535088285#40442221535088285|text=Connecting a phantom powered condenser mic to to Yamaha Tyros 5}} ;Answer: Yes. On the {{T1}} use the Preamp Output. On the {{ToneMatch Mixer}} use one of the Aux Outputs.
  3 KB (474 words) - 13:59, 23 April 2019

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)