ToneMatch Mixer Phantom Power to Tyros 5 Microphone Input

From Bose Portable PA Encyclopedia
Jump to: navigation, search

Introduction

Question
I have a Yamaha Tyros 5 that I run thru the Bose T1 tone match. The Keyboard has an XLR mic connection with no phantom power. I would like to use a condenser mic that needs phantom power. I would love to record using the harmonies on the keyboard. Now is it possible to connect and run the mic thru the input on Ch 1 with phantom power on the T1 tone match and run the out from ch1 to the keyboard would that work?

Source: Connecting a phantom powered condenser mic to to Yamaha Tyros 5

Answer
Yes. On the T1 ToneMatch Audio Engine use the Preamp Output. On the ToneMatch Mixer[1] use one of the Aux Outputs.

If you have questions about this article please see Connecting a phantom powered condenser mic to to Yamaha Tyros 5

Tyros 5

By connecting a microphone to the [MIC INPUT] jack (accepts either XLR or standard 1/4” phone plug connectors), you can enjoy singing along with your keyboard performance or with Song playback. The instrument outputs your vocals through the connected speaker system (page 15). Moreover, you can automatically apply various Vocal Harmony effects to your voice as you sing, or you can use Synth Vocoder to graft the unique characteristics of your voice onto synthesizer and other sounds.

From the Yamaha Tyros 5 Owners Manual

T1 ToneMatch Audio Engine

T1 Phantom to Tyros 4 mic input 1.png

  1. Connect the microphone to the T1 Channel 1 XLR input
    T1 Phantom to Tyros 4 mic input 2.png
  2. Turn on Phantom Power
  3. Connect the T1 Channel 1 Preamp Output to the Tyros 5 microphone input using a 1/4 inch (6.3mm) Tip-Sleeve cable.
    T1 Phantom to Tyros 4 mic input 3.png
    • It's not clear if the Tyros 5 microphone input requires a 1/4 inch (6.3 mm) Tip-Ring-Sleeve cable so if the 1/4 inch (6.3mm) Tip-Sleeve cable is noisy you can try the 1/4 inch (6.3 mm) Tip-Ring-Sleeve cable.
  4. On the T1, set the input trim so you get a solid green light.
  5. On the Tyros 5 set the input trim
    T1 Phantom to Tyros 4 mic input 4.png

T4S ToneMatch mixer/T8S ToneMatch mixer

Question
Can I use a T4S ToneMatch mixer/T8S ToneMatch mixer to provide phantom power to a microphone?
Answer
The T4S/T8S does not have Preamp Outputs like the T1. However, you can connect a microphone to the T4S/T8S (e.g., channel 1). Then set up the Aux 1 output to send the microphone signal to the Tyros 5 microphone input. For more detail see T4S Aux Outputs/T8S Aux Outputs
  1. ↑ T4S ToneMatch mixer or T8S ToneMatch mixer or T1 ToneMatch Audio Engine
Retrieved from "https://toonz.ca/bose/wiki/index.php?title=ToneMatch_Mixer_Phantom_Power_to_Tyros_5_Microphone_Input&oldid=20972"