T1 ToneMatch® Audio Engine / Routing for Effects

There are several less than obvious things you can do with effects through the T1 ToneMatch Audio Engine.

Parallel Effects

If you want to swap between two sets of effects or run two sets of effects at the same time (for example: two delays, two modulation effects, two reverbs)  try this.

Assume that you are using Channel 1 as the input where you want to do this:

• Set the effects you want on Channel 1
• Take a ¼ inch jack cable from the Channel 1 PreAmp Out to Channel 2 input
• Add the second layer of effects you want to Channel 2
• Now use the FX Mute buttons for Channels 1 and 2 to set which banks of effects will be used
  • Channel 1 only
  • Channel 2 only
    
  • Channel 1 and Channel 2 in parallel
    

Serial Effects

If you want to run some effects and then add more effects in series then take the output of one or more T1 ToneMatch Audio Engine Channels to the Aux Output, then take the Aux Output and use that as the input to another T1® Channel

Assume that you are using Channel 1 as the input where you want to do this:

• Set the effects that you want on Channel 1
• Set the Aux tap to Pre
• Take a ¼ inch jack cable from the Aux Out to Channel 2 input
• Apply effects that you want applied to the output of Channel 1
• Now use the FX Mute buttons for Channels 1 and 2 to set which banks of effects will be used
  • Channel 1 only
  • Channel 2 only
    
  • Channel 1 and Channel 2 in series
    

This article is a stub. Please help us if you can by expanding it.