Difference between revisions of "T1 ToneMatch® Audio Engine to Two Model II Power Stands"

From Bose Portable PA Encyclopedia
Jump to: navigation, search
m
m
Line 1: Line 1:
−
Please note: Bose recommends that if you have two L1® Systems using the same source, that the L1®s be placed at least 20 feet apart (6 meters). This is to avoid  [Multiple_Source_Interference]Multiple Source Interference]   
+
Please note: Bose recommends that if you have two L1® Systems using the same source, that the L1®s be placed at least 20 feet apart (6 meters). This is to avoid  [[Multiple_Source_Interference|Multiple Source Interference]]   
  
 
[[Image:T1TwoModelII.png]]
 
[[Image:T1TwoModelII.png]]

Revision as of 11:50, 17 March 2013

Please note: Bose recommends that if you have two L1® Systems using the same source, that the L1®s be placed at least 20 feet apart (6 meters). This is to avoid Multiple Source Interference

T1TwoModelII.png

System 1

Connect the first system with the ToneMatch cable that came with the T1®.

  • T1® ToneMatch port to Model II Power Stand ToneMatch port.
System 2

Connect the second system with a ¼ inch jack Tip-Ring-Sleeve cable

  • T1® Master Output to Model II Power Stand Analog input
    • on the Model II Power Stand set the analog input trim to "3" and adjust as necessary to get a good balance with the other system.
    • For best results use a Tip-Ring-Sleeve (balanced) connection.
      TrsMtrsM.png
      You can use a Tip-Sleeve (unbalanced connection) but the Tip-Ring-Sleeve (balanced connection is preferred).
Retrieved from "https://toonz.ca/bose/wiki/index.php?title=T1_ToneMatch®_Audio_Engine_to_Two_Model_II_Power_Stands&oldid=15827"