Difference between revisions of "Template:L1 Model II Analog Input Gain Staging"
(Created page with " === {{Model II}} Analog Input === The Analog input is a ¼ inch balanced input jack. Image:Model 1S Analog Input Detail.png ==== Analog input trim (volume, or gain)...") |
m (→Analog input trim (volume, or gain) control) |
||
Line 13: | Line 13: | ||
# Set the '''Trim''' control on the power stand to the 0 (zero) position. | # Set the '''Trim''' control on the power stand to the 0 (zero) position. | ||
− | # Connect the | + | # Connect the Third Party Mixer Main Output to the Analog Input |
− | # Adjust the volume of the | + | # Adjust the volume of the Third Party Mixer Main Output to the maximum output without distortion or clipping. This may be marked as '''unity''' or '''0 dB'''. |
− | # While playing the source, increase the '''Trim''' level so that the '''Signal/Clip''' indicator glows green or yellow. This will probably be around 9:00- | + | |
+ | # While playing the source, increase the '''Trim''' level so that the '''Signal/Clip''' indicator glows green or yellow. This will probably be around 9:00-12:00 o'clock | ||
# If the '''Signal/Clip''' indicator glows red, decrease the '''Trim''' level so that it glows only green or yellow. | # If the '''Signal/Clip''' indicator glows red, decrease the '''Trim''' level so that it glows only green or yellow. | ||
[[Image:Model II Analog Input Level Green.png|Model 1S Analog Input]] | [[Image:Model II Analog Input Level Green.png|Model 1S Analog Input]] | ||
---- | ---- | ||
+ | [[Category:Mixer]] | ||
[[Category:Connections]] | [[Category:Connections]] | ||
[[Category:Model II]] | [[Category:Model II]] |
Revision as of 22:16, 6 April 2019
L1 Model II Analog Input
The Analog input is a ¼ inch balanced input jack.
Analog input trim (volume, or gain) control
Setting the trim level on the Model II Power Stand is a one-time step. Once you have matched the output of the ToneMatch mixer to the input of the L1 you don't need to adjust it again.
- Set the Trim control on the power stand to the 0 (zero) position.
- Connect the Third Party Mixer Main Output to the Analog Input
- Adjust the volume of the Third Party Mixer Main Output to the maximum output without distortion or clipping. This may be marked as unity or 0 dB.
- While playing the source, increase the Trim level so that the Signal/Clip indicator glows green or yellow. This will probably be around 9:00-12:00 o'clock
- If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.