Template:L1 Model II Analog Input Gain Staging Device

From Bose Portable PA Encyclopedia
Revision as of 10:29, 8 April 2019 by ST (talk | contribs) (→‎{{Model II}} Analog Input)
Jump to: navigation, search

L1 Model II Analog Input

The Analog input is a ¼ inch balanced input jack.

Model 1S Analog Input Detail.png


Analog input trim (volume, or gain) control

Setting the trim level on the Model II Power Stand is a one-time step. Once you have matched the output of the ToneMatch mixer to the input of the L1 you don't need to adjust it again.


Model II Analog Input Trim.png

  1. Set the Trim control on the power stand to the 0 (zero) position.
  2. Connect the source device Main Output to the Analog Input
  3. Adjust the volume of the source device Main Output to the maximum output without distortion.
    • On analog consoles this may be marked as unity or 0 dB.
    • On digital consoles this may be marked as -18 dBFS[1]<ref>dBU vs dBFS. The exact value (-18 dBFS to -24 dBFS) may vary depending your location.
  4. While playing the source, increase the Trim level so that the Signal/Clip indicator glows green or yellow. This will probably be around 9:00-11:00 o'clock
  5. If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.

Model 1S Analog Input

  1. ↑ dBFS
Retrieved from "https://toonz.ca/bose/wiki/index.php?title=Template:L1_Model_II_Analog_Input_Gain_Staging_Device&oldid=20872"