Template:ToneMatch Mixers to F1 Model 812

1. Set ToneMatch Trim controls and set the input volumes as high as possible without input clipping. You can use the Prefs | Input Level on the ToneMatch mixer to monitor the input level.
2. Unmute the channels on the ToneMatch mixer and adjust your channel volumes to stay between 0 dB and +6 dB at the master output. You can monitor this visually on the T8S LED or in the Prefs | Output Level on the ToneMatch mixer.

-->

Gain Staging

For each F1 Model 812 Flexible Array Loudspeaker

F1 Model 812 Flexible Array Loudspeaker Channel 1 Combo Input

The use an XLR or ¼ inch Tip-Ring-Sleeve jack cable.

MIC / LINE LEVEL

Set this to LINE LEVEL

Volume Control

Use the Input 1 volume control.

1. Set the Input 1 Volume control to the 0 (zero) position.
2. Connect the T8S ToneMatch mixer Main Output to the Input 1
3. Adjust the volume of the T8S ToneMatch mixer Main Output to the maximum output without distortion. This is probably between 10:00 o'clock and 12:00 o'clock on the Master Output
4. While playing music through the T8S ToneMatch mixer, increase the Volume level so that the Signal/Clip indicator glows green with flickers of red. This will probably be around 9:00-11:00 o'clock
5. If the Signal/Clip indicator glows red, decrease the Volume level so that it glows only green or red. If you see red flashes longer than one second, turn down the volume.

---