Difference between revisions of "Mixer / Mackie / 1202-VLZ"
m |
m (→Notes about MIC/Line Switch) |
||
Line 26: | Line 26: | ||
=== Notes about MIC/Line Switch === | === Notes about MIC/Line Switch === | ||
− | Details of the MIC/Line Switch from | + | When using an XLR cable between the mixer and the Model I or Classic Power Stand, you wnat to set the mixer MIC / Line Switch to MIC because the Model I / Classic Channel 1/2 XLR Inputs are designed to accept a Microphone level input. The mixer allows you to match that requirement by using the MIC setting. |
+ | |||
+ | [img]Image:ModelIChannel1InputXLRisMIC.jpg[/img] | ||
+ | |||
+ | |||
+ | |||
+ | Details of the MIC/Line Switch from pages 15 and 26 of | ||
[[Image:Mackie1202VLZProOutputDiagram.jpg]] | [[Image:Mackie1202VLZProOutputDiagram.jpg]] |
Revision as of 10:55, 18 March 2012
Mackie 1202-VLZ
Contents
Summary
You can use either the XLR outputs on the rear panel (be sure to set the MIC button "in")
- - or -
Use the ¼ inch phone jacks on the top.
Use the XLR - or - ¼ inch phone jack (Tip-Sleeve) outputs to
- The PS1 Power Stand (Classic) / Model I Channels 1 or 2 if you want to use the Presets and the R1 Remote Tone and Level Controls
OR
- The PS1 Power Stand (Classic) / Model I Channels 3 or 4 if you prefer to leave Channels 1 or 2 open for other inputs. You will have to control Tone and relative Level (between the Channels) at your input source, as you do not have this control over Channels 3 and 4 in the PS1 Power Stand (Classic) / Model I or the R1 Remote.
- If you want to use the Balanced XLR outputs use the MIC setting in the picture above.
¼ Inch with suitable output
for PS1 Powerstand Channel 1 or 2 inputs
You can use TS (Tip Sleeve) unbalanced cables, or TRS (Tip Ring Sleeve) balanced cables, but since the ¼ inch phone connections at the Bose Classic and Model I Power Stand are unbalanced there is no particular benefit using balanced cables.
¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)
This should work fine.
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced)
This should work fine.
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)
This should also work, but likely no better than a simple ¼ Inch Tip-Sleeve to Tip-Sleeve cable. This is because the ¼ Inch input on the Bose System is Tip-Sleeve (unbalanced) anyway.
Links:
Notes about MIC/Line Switch
When using an XLR cable between the mixer and the Model I or Classic Power Stand, you wnat to set the mixer MIC / Line Switch to MIC because the Model I / Classic Channel 1/2 XLR Inputs are designed to accept a Microphone level input. The mixer allows you to match that requirement by using the MIC setting.
[img]Image:ModelIChannel1InputXLRisMIC.jpg[/img]
Details of the MIC/Line Switch from pages 15 and 26 of