Difference between revisions of "PS1 Powerstand/Effects/Serial"
m |
m |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 3: | Line 3: | ||
Serial Effects - Excerpt from the {{PS1}} Manual | Serial Effects - Excerpt from the {{PS1}} Manual | ||
| − | http://bose.infopop.cc/eve/forums/a/ga/ul/1411053732/inlineimg/Y/effectsSerial%5B1%5D.gif | + | [[Image:PS1InsertParallela.png]] |
| + | <!-- | ||
| + | http://bose.infopop.cc/eve/forums/a/ga/ul/1411053732/inlineimg/Y/effectsSerial%5B1%5D.gif --> | ||
<!-- | <!-- | ||
[[Image:PS1Channel1Insert.png]] | [[Image:PS1Channel1Insert.png]] | ||
| Line 18: | Line 20: | ||
--> | --> | ||
<noinclude> | <noinclude> | ||
| + | == Summary of Lines Out from the Power Stand == | ||
| + | {{#lst:PS1 Powerstand Connections / Line Out|Connections}} | ||
| + | ---- | ||
<references/> | <references/> | ||
Latest revision as of 10:32, 8 July 2010
Contents
Connections at the PS1 Power Stand (Classic) / Model I
Serial Effects - Excerpt from the PS1 Power Stand (Classic) / Model I Manual
Insert Cable
Typical Insert Cable Hosa STP204
A common problem is with the way some Insert Cables are labelled. This is how the connections are run at the Insert Point of the PS1 Powerstand.
and this is connected to one of the PS1 Powerstand Insert Points
Summary of Lines Out from the Power Stand
PS1 Connections Lines Out
Line Out (XLR balanced) for Channels 1 and 2
- post trim (+4 dBu nominal)
Insert Send
- post trim,
- post channel volume
SPDIF Data OUT
- Post trim
- Input Trim
- R1 Remote Channel volume
- Insert returns
- Pre
- Preset
- Tone controls
- R1 Remote Master volume.
- SPDIF is channels 1 & 2 only.
The Data OUT is a SPDIF output with a sampling rate of 48KHz.
Set your recording software as below if given the options
- 24 Bit
- 48 KHz
- S/PDIF (RCA)
See: Recording Through the PS1 — Message Board Discussion.