Mixer / Behringer / UB802

Behringer Eurorack UB502 / UB802 / UB1002 / UB1202 Mixer

L1 Model I

Classic

Summary

Use unbalanced ¼ inch Tip-Sleeve phone jack cables from the Mixer to the PS1 Power Stand (Classic) / Model I. See green highlighted areas below.

Use the ¼ inch phone jack (Tip-Sleeve) outputs to

• The PS1 Power Stand (Classic) / Model I Channels 1 or 2 if you want to use the Presets and the R1 Remote Tone and Level Controls
  OR
  
• The PS1 Power Stand (Classic) / Model I Channels 3 or 4 if you prefer to leave Channels 1 or 2 open for other inputs. You will have to control Tone and relative Level (between the Channels) at your input source, as you do not have this control over Channels 3 and 4 in the PS1 Power Stand (Classic) / Model I or the R1 Remote.

The main outputs from this mixer are unbalanced ¼ inch Tip-Sleeve phone jacks that you can run to the Channel 1 or 2 ¼ inch Tip-Sleeve inputs.

Outputs

¼ Inch with suitable output

for PS1 Powerstand Channel 1 or 2 inputs

You can use TS (Tip Sleeve) unbalanced cables, or TRS (Tip Ring Sleeve) balanced cables, but since the ¼ inch phone connections at the Bose Classic and Model I Power Stand are unbalanced there is no particular benefit using balanced cables.

¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)

This should work fine.

¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced)

This should work fine.

¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)

This should also work, but likely no better than a simple ¼ Inch Tip-Sleeve to Tip-Sleeve cable. This is because the ¼ Inch input on the Bose System is Tip-Sleeve (unbalanced) anyway.

Links:

• Behringer Eurorack UB502 / UB802 / UB1002 / UB1202 Manual

---