Difference between revisions of "PS1 Powerstand Connections / Line Out"
m (→SPDIF Data OUT: clarify post/pre and recording settings) |
m (→SPDIF Data OUT: formatting) |
||
| Line 11: | Line 11: | ||
=== SPDIF Data OUT === | === SPDIF Data OUT === | ||
* Post trim | * Post trim | ||
| − | * | + | ** Input Trim |
| − | * | + | ** R1 Remote Channel volume |
| − | * Pre Preset | + | **Insert returns |
| − | * | + | * Pre |
| − | * | + | ** Preset |
| + | ** Tone controls | ||
| + | ** R1 Remote Master volume. | ||
* SPDIF is channels 1 & 2 only. | * SPDIF is channels 1 & 2 only. | ||
Revision as of 14:30, 31 December 2008
PS1 Connections Lines Out
Contents
Summary
Line Outs (XLR balanced) for Channels 1 and 2
- post trim (+4 dBu nominal)
Insert Send
- post trim,
- post channel volume
SPDIF Data OUT
- Post trim
- Input Trim
- R1 Remote Channel volume
- Insert returns
- Pre
- Preset
- Tone controls
- R1 Remote Master volume.
- SPDIF is channels 1 & 2 only.
The Data OUT is a SPDIF output with a sampling rate of 48KHz.
Set your recording software as below if given the options
- 24 Bit
- 48 KHz
- S/PDIF (RCA)
See: Recording Through the PS1 — Message Board Discussion.
Line Outs (XLR balanced) for Channels 1 and 2
- post trim (+4 dBu nominal)
For Channels One or Two you can run an XLR cable to the House or recording console like this. The outputs are post-trim (+4 dBu nominal).
This is not suitable for connection to another PS1 Power Stand (Classic) / Model I as the output level is too high for a PS1 Power Stand (Classic) / Model I Channel 1 or 2 input. If you want to connect one L1® to another please see: PS1 Powerstand / Daisy Chain
Line Out from Insert Point
- access from the "ring" connection at the Insert Point
- post trim
- post R1 Remote Channel Level
For Channels One or Two insert a 1/4 inch cable halfway into the Insert jack to get a signal that is controlled by the volume control on the Remote. This is also known as the Half Insert method. For more information about 1/4 cables see Tip Ring Sleeve connections. The rectangular box shown below the input panel is a DI, used to output the signal to a console or house system.
Line Out from Channels 3 or 4
There is no output from the PS1 Power Stand (Classic) / Model I for Channels 3 or 4. To share inputs with an external system use a DI.
