Difference between revisions of "Securing the T1® to the Microphone Stand Bracket"
m |
m |
||
Line 1: | Line 1: | ||
+ | |||
+ | * The bracket that sits parallel to the floor has a bevel on the top. The bevel should run down, facing you. If the bevel runs down away from you, the bracket is upside down and the {{T1 nl}} will not sit properly on top of it. | ||
+ | * Secure the ToneMatch® cable to your microphone stand, above the {{T1 nl}}. This will help keep it secure on the bracket and help to keep it from hitting the floor if it becomes dislodged from the bracket. | ||
+ | |||
This is how I secure the T1® to the [[T1 ToneMatch® Audio Engine / Microphone Stand Bracket|T1® Microphone Stand Bracket]] | This is how I secure the T1® to the [[T1 ToneMatch® Audio Engine / Microphone Stand Bracket|T1® Microphone Stand Bracket]] | ||
− | |||
# There is a velcro strap on the black ToneMatch cable. | # There is a velcro strap on the black ToneMatch cable. | ||
Line 9: | Line 12: | ||
# Finally, I set the T1® on top of the bracket. | # Finally, I set the T1® on top of the bracket. | ||
+ | [[Image:T1 Strapped 02.png]] | ||
+ | |||
+ | |||
[[Image:T1 Strapped 01.png]] | [[Image:T1 Strapped 01.png]] | ||
− | + | The white cable is a [[T1#Cables|network cable (Cat-5)]] instead of the ToneMatch® cable | |
− | [[ | ||
Revision as of 13:35, 18 February 2013
- The bracket that sits parallel to the floor has a bevel on the top. The bevel should run down, facing you. If the bevel runs down away from you, the bracket is upside down and the T1 ToneMatch® Audio Engine will not sit properly on top of it.
- Secure the ToneMatch® cable to your microphone stand, above the T1 ToneMatch® Audio Engine. This will help keep it secure on the bracket and help to keep it from hitting the floor if it becomes dislodged from the bracket.
This is how I secure the T1® to the T1® Microphone Stand Bracket
- There is a velcro strap on the black ToneMatch cable.
- I use the velcro to secure the ToneMatch cable to the microphone stand just above the Microphone Stand Adapter (the thing that clamps around the mic stand).
- Then I insert the ToneMatch cable into the T1®. It locks into place.
- At this point, most people would put the T1® on the bracket and attach the other cables.
- I insert all the other cables into the T1® before I put it on the bracket. I do it this way because I have all my cables strapped to the microphone stand (I don't take them off between gigs). So there's no hanging stress from those either.
- Finally, I set the T1® on top of the bracket.
The white cable is a network cable (Cat-5) instead of the ToneMatch® cable
— source
— source