Difference between revisions of "PS1 Powerstand Connections / Line Out"
(inclusions for XLR Insert Channels 3/4) |
m (summary, formatting) |
||
| Line 1: | Line 1: | ||
<big>'''PS1 Connections Lines Out '''</big> | <big>'''PS1 Connections Lines Out '''</big> | ||
| − | + | == Summary == | |
| − | == XLR Line Outs Channels 1 and 2 == | + | === XLR Line Outs Channels 1 and 2 === |
* post trim (+4 dBu nominal) | * post trim (+4 dBu nominal) | ||
| − | == Insert Send == | + | === Insert Send === |
* post trim, | * post trim, | ||
* post channel volume | * post channel volume | ||
| − | == SPDIF Data OUT == | + | === SPDIF Data OUT === |
* post trim, | * post trim, | ||
* post channel volume and | * post channel volume and | ||
| Line 16: | Line 16: | ||
The Data OUT is a SPDIF output with a sampling rate of 48KHz | The Data OUT is a SPDIF output with a sampling rate of 48KHz | ||
| − | |||
{{:PS1 Powerstand Connections/Line Out/XLR}} | {{:PS1 Powerstand Connections/Line Out/XLR}} | ||
| − | |||
{{:PS1 Powerstand Connections/Line Out/Insert}} | {{:PS1 Powerstand Connections/Line Out/Insert}} | ||
| − | |||
{{:PS1 Powerstand Connections/Line Out/Channel 3/4}} | {{:PS1 Powerstand Connections/Line Out/Channel 3/4}} | ||
Revision as of 14:28, 14 November 2006
PS1 Connections Lines Out
Contents
Summary
XLR Line Outs Channels 1 and 2
- post trim (+4 dBu nominal)
Insert Send
- post trim,
- post channel volume
SPDIF Data OUT
- post trim,
- post channel volume and
- post insert returns.
- It's PRE preset, tone controls & master volume.
- SPDIF is channels 1 & 2 only.
The Data OUT is a SPDIF output with a sampling rate of 48KHz
Line Outs (XLR balanced) for Channels 1 and 2
- post trim (+4 dBu nominal)
For Channels One or Two you can run an XLR cable to the House or recording console like this. The outputs are post-trim (+4 dBu nominal).
This is not suitable for connection to another PS1 Power Stand (Classic) / Model I as the output level is too high for a PS1 Power Stand (Classic) / Model I Channel 1 or 2 input. If you want to connect one L1® to another please see: PS1 Powerstand / Daisy Chain
Line Out from Insert Point
- access from the "ring" connection at the Insert Point
- post trim
- post R1 Remote Channel Level
For Channels One or Two insert a 1/4 inch cable halfway into the Insert jack to get a signal that is controlled by the volume control on the Remote. This is also known as the Half Insert method. For more information about 1/4 cables see Tip Ring Sleeve connections. The rectangular box shown below the input panel is a DI, used to output the signal to a console or house system.
Line Out from Channels 3 or 4
There is no output from the PS1 Power Stand (Classic) / Model I for Channels 3 or 4. To share inputs with an external system use a DI.
