Difference between revisions of "PS1 Powerstand Connections / Line Out"
m ({{Classic icon}}{{Model I icon}}) |
m (→SPDIF Data OUT: clarify post/pre and recording settings) |
||
| Line 10: | Line 10: | ||
=== SPDIF Data OUT === | === SPDIF Data OUT === | ||
| − | * | + | * Post trim |
| − | * | + | * Post channel volume |
| − | * | + | * Post insert returns |
| − | * | + | * Pre Preset |
| + | * Pre Tone controls | ||
| + | * Pre Master volume. | ||
* SPDIF is channels 1 & 2 only. | * SPDIF is channels 1 & 2 only. | ||
| − | The Data OUT is a SPDIF output with a sampling rate of 48KHz | + | The Data OUT is a SPDIF output with a sampling rate of 48KHz. |
| + | |||
| + | Set your recording software as below if given the options | ||
| + | * 24 Bit | ||
| + | * 48 KHz | ||
| + | * S/PDIF (RCA) | ||
| + | |||
| + | See: [http://bose.infopop.cc/eve/forums/a/tpc/f/3976055944/m/1431057611?r=1771034582#1771034582 Recording Through the PS1] — Message Board Discussion. | ||
{{:PS1 Powerstand Connections/Line Out/XLR}} | {{:PS1 Powerstand Connections/Line Out/XLR}} | ||
Revision as of 14:28, 31 December 2008
PS1 Connections Lines Out
Contents
Summary
Line Outs (XLR balanced) for Channels 1 and 2
- post trim (+4 dBu nominal)
Insert Send
- post trim,
- post channel volume
SPDIF Data OUT
- Post trim
- Post channel volume
- Post insert returns
- Pre Preset
- Pre Tone controls
- Pre Master volume.
- SPDIF is channels 1 & 2 only.
The Data OUT is a SPDIF output with a sampling rate of 48KHz.
Set your recording software as below if given the options
- 24 Bit
- 48 KHz
- S/PDIF (RCA)
See: Recording Through the PS1 — Message Board Discussion.
Line Outs (XLR balanced) for Channels 1 and 2
- post trim (+4 dBu nominal)
For Channels One or Two you can run an XLR cable to the House or recording console like this. The outputs are post-trim (+4 dBu nominal).
This is not suitable for connection to another PS1 Power Stand (Classic) / Model I as the output level is too high for a PS1 Power Stand (Classic) / Model I Channel 1 or 2 input. If you want to connect one L1® to another please see: PS1 Powerstand / Daisy Chain
Line Out from Insert Point
- access from the "ring" connection at the Insert Point
- post trim
- post R1 Remote Channel Level
For Channels One or Two insert a 1/4 inch cable halfway into the Insert jack to get a signal that is controlled by the volume control on the Remote. This is also known as the Half Insert method. For more information about 1/4 cables see Tip Ring Sleeve connections. The rectangular box shown below the input panel is a DI, used to output the signal to a console or house system.
Line Out from Channels 3 or 4
There is no output from the PS1 Power Stand (Classic) / Model I for Channels 3 or 4. To share inputs with an external system use a DI.
