PS1 Powerstand Connections / Line Out

PS1 Connections Lines Out

Classic

L1 Model I

Summary

Line Outs (XLR balanced) for Channels 1 and 2

• post trim (+4 dBu nominal)

Insert Send

• post trim,
• post channel volume

SPDIF Data OUT

• Post trim
  • Input Trim
  • R1 Remote Channel volume
  • Insert returns
• Pre
  • Preset
  • Tone controls
  • R1 Remote Master volume.
• SPDIF is channels 1 & 2 only.

The Data OUT is a SPDIF output with a sampling rate of 48KHz.

Set your recording software as below if given the options

• 24 Bit
• 48 KHz
• S/PDIF (RCA)

See: Recording Through the PS1 — Message Board Discussion.

Line Outs (XLR balanced) for Channels 1 and 2

• post trim (+4 dBu nominal)

For Channels One or Two you can run an XLR cable to the House or recording console like this. The outputs are post-trim (+4 dBu nominal).

This is not suitable for connection to another PS1 Power Stand (Classic) / Model I as the output level is too high for a PS1 Power Stand (Classic) / Model I Channel 1 or 2 input. If you want to connect one L1^® to another please see: PS1 Powerstand / Daisy Chain

---

L1 Model I

Classic

Line Out from Insert Point

• access from the "ring" connection at the Insert Point
• post trim
• post R1 Remote Channel Level

For Channels One or Two insert a 1/4 inch cable halfway into the Insert jack to get a signal that is controlled by the volume control on the Remote. This is also known as the Half Insert method. For more information about 1/4 cables see Tip Ring Sleeve connections. The rectangular box shown below the input panel is a DI, used to output the signal to a console or house system.

---

Line Out from Channels 3 or 4

Classic

L1 Model I

There is no output from the PS1 Power Stand (Classic) / Model I for Channels 3 or 4. To share inputs with an external system use a DI.

---

---