L1® System Holistic View

A Holistic View of the L1^®

Classic

The L1 System (Physical)

Here is one way you can think about the L1 System.

L1 Cylindrical Radiator^® loudspeaker as one loudspeaker

Think of the L1 Cylindrical Radiator^® loudspeaker (Yellow highlight) is a single loudspeaker with 24 drivers (2.5 inch) supplied by 500 watts for the L1 Classic and 250 watts for the L1 Model I. Note: the L1 Model I provides the same audible output. It is just more efficient than the L1 Classic.

Two B1 Bass Modules as a one bass loudspeaker

Think of the pair of B1 Bass Modules (Purple highlight) is a single bass loudspeaker with 4 (6.5 inch) drivers supplied by 250 watts.

That's 750 watts in total for the L1 Classic and 500 watts total for the L1 Model I

The L1 System (Amplifiers & Power)

Note: This information below is applicable to the L1 Classic and not the L1 Model I

L1 Cylindrical Radiator^® loudspeaker

The L1 Cylindrical Radiator^® loudspeaker This is one loudspeaker that happens to break down into two pieces for travel. This is driven by two separate amps, but this is not important because under normal circumstances both amps are driven identically. One drives the top half of the L1 Cylindrical Radiator^® loudspeaker and the other drives the bottom half. Because the L1 Cylindrical Radiator^® loudspeaker should always be operated as a single unit, what happens when you break it down isn't relevant.

B1 Bass Modules

If you break the pair of B1 Bass Modules in half, and use just one of them, it draws 125 watts.

If you don't use the B1 Bass Modules at all, the amp that is normally used to drive them is idle.

Model I

L1 Model I

The L1 Model I handles the B1s the same way, but with a more efficient design provides the same audible output from the L1 Cylindrical Radiator^® loudspeaker with a single 250 watt amp.

---