PS1 Powerstand / Daisy Chain

L1 Model I

Classic

On the relatively rare occasion where you might need to connect the output from one PS1 Power Stand (Classic) / Model I to another PS1 Power Stand (Classic) / Model I. Here are some ways to approach it.

Two PS1 Power Stand (Classic) / Model Is for one Vocal

You can

• Run your microphone into the first L1^® PS1 Powerstand (let's say - Channel 1).
• In the Channel 1 section run an XLR cable from the Channel 1 Line Out
• At the other end of the cable connect a Pad. The people-at-Bose usually recommend a -20 dBu pad. Some owners have reported success with a -10 dBu pad.
• Connect the Pad to the second PS1 Power Stand (Classic) / Model I Channel 1 or 2.
• On the first PS1 Power Stand (Classic) / Model I, set the input trim appropriately.
• Choose the best preset for your microphone.
• On the second PS1 Power Stand (Classic) / Model I, the input trim should be similar to what you set on the first one, but check the trim o/l light for a solid green light (occasional red flickers are okay).
• On the second PS1 Power Stand (Classic) / Model I, use the same preset as you used for the first one.

Arrows indicate the direction the signal is flowing.

• Position the two L1 s at least 20 feet apart if possible to avoid the possibility of odd phase effects in the audience. More detail: Phase Cancellation
• Close up view of the Input Panel

Two PS1 Power Stand (Classic) / Model Is for Mono Tracks (or one side of stereo pair)

In this example, we are using Channel 2 so that you leave Channel 1 available for another input like a vocal.

You can

• Run your input into the first L1™ PS1 Powerstand (let's say - Channel 2).
• In Channel 2 section run an XLR cable from the Channel 2 Line Out
• At the other end of the cable connect a Pad. The people-at-Bose usually recommend a -20 dBu pad. Some owners have reported success with a -10 dBu pad.
• Connect the Pad to the second PS1 Power Stand (Classic) / Model I Channel 2.
• On the first PS1 Power Stand (Classic) / Model I, set the input trim appropriately.
• Choose the best preset for your microphone.
• On the second PS1 Power Stand (Classic) / Model I, the input trim should be similar to what you set on the first one, but check the trim o/l light for a solid green light (occasional red flickers are okay).
• On the second PS1 Power Stand (Classic) / Model I, use the same preset as you used for the first one.
• For prerecored music or tracks or keyboards you want B1 Bass Modules as close together as possible, and the L1™s close together -or- at least 20 feet apart.

• Close up view of the Input Panel

XLR Female to ¼ Inch Tip-Sleeve Male

Here is another method - use a cable with a XLR Female to ¼ Inch Tip-Sleeve Male from a Powerstand Line OUT to Channels 1, 2, 3 or 4 on a second Powerstand.

---