Securing the T1® to the Microphone Stand Bracket

• The bracket that sits parallel to the floor has a bevel on the top. The bevel should run down, facing you. If the bevel runs down away from you, the bracket is upside down and the T1 ToneMatch^® Audio Engine will not sit properly on top of it.
• Secure the ToneMatch® cable to your microphone stand, above the T1 ToneMatch^® Audio Engine. This will help keep it secure on the bracket and help to keep it from hitting the floor if it becomes dislodged from the bracket.

This is how I secure the T1® to the T1® Microphone Stand Bracket

1. There is a velcro strap on the black ToneMatch cable.
2. I use the velcro to secure the ToneMatch cable to the microphone stand just above the Microphone Stand Adapter (the thing that clamps around the mic stand).
3. Then I insert the ToneMatch cable into the T1®. It locks into place.
4. At this point, most people would put the T1® on the bracket and attach the other cables.
5. I insert all the other cables into the T1® before I put it on the bracket. I do it this way because I have all my cables strapped to the microphone stand (I don't take them off between gigs). So there's no hanging stress from those either.
6. Finally, I set the T1® on top of the bracket.

The white cable is a network cable (Cat-5) instead of the ToneMatch® cable

— source

— source

---