Difference between revisions of "L1® Compact / Connection from a Mixer"
m (→Cables) |
m (Added summary) |
||
Line 1: | Line 1: | ||
− | Summary | + | ===Summary=== |
+ | You need a mono output from the mixer to {{Compact}} Channel 2 ¼ inch jack or you can run a stereo source to the 1/8 input or the RCA jack inputs. | ||
You can used ¼ inch jack cables. Balanced or unbalanced will work fine. '''DO NOT use a stereo''' ¼ inch jack Tip-Ring-Sleeve connection. You may suffer significant signal loss. If you must make a stereo connection then use the 1/8 inch stereo connection or the RCA jack inputs. | You can used ¼ inch jack cables. Balanced or unbalanced will work fine. '''DO NOT use a stereo''' ¼ inch jack Tip-Ring-Sleeve connection. You may suffer significant signal loss. If you must make a stereo connection then use the 1/8 inch stereo connection or the RCA jack inputs. | ||
Line 5: | Line 6: | ||
=== ¼ inch jack Cables === | === ¼ inch jack Cables === | ||
+ | You can use TS (Tip Sleeve) unbalanced cables, OR TRS (Tip Ring Sleeve) balanced cables. If the cable uses ¼ inch jack plugs and the ends are the same, then the cable should be fine. | ||
+ | NOTE: '''DO NOT use a stereo''' ¼ inch jack Tip-Ring-Sleeve connection. You may suffer significant signal loss. If you must make a stereo connection then use the 1/8 inch stereo connection or the RCA jack inputs. | ||
{{#lst:T1 ToneMatch® Audio Engine / 1/4 inch Output Connections to L1® Family Members|Balanced}} | {{#lst:T1 ToneMatch® Audio Engine / 1/4 inch Output Connections to L1® Family Members|Balanced}} |
Revision as of 12:35, 15 December 2009
Contents
Summary
You need a mono output from the mixer to L1 Compact Channel 2 ¼ inch jack or you can run a stereo source to the 1/8 input or the RCA jack inputs.
You can used ¼ inch jack cables. Balanced or unbalanced will work fine. DO NOT use a stereo ¼ inch jack Tip-Ring-Sleeve connection. You may suffer significant signal loss. If you must make a stereo connection then use the 1/8 inch stereo connection or the RCA jack inputs.
¼ inch jack Cables
You can use TS (Tip Sleeve) unbalanced cables, OR TRS (Tip Ring Sleeve) balanced cables. If the cable uses ¼ inch jack plugs and the ends are the same, then the cable should be fine.
NOTE: DO NOT use a stereo ¼ inch jack Tip-Ring-Sleeve connection. You may suffer significant signal loss. If you must make a stereo connection then use the 1/8 inch stereo connection or the RCA jack inputs.
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)
A balanced connection is preferred and will provide better noise rejection over greater distances than the unbalanced connection.
¼ Inch Tip-Ring-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)
This should work fine but a balanced connection (immediately above) is preferred especially if you will have cable runs in excess of 20 feet (6 meters) or if you hear line noise, hum or hiss.
Channel 2 Connection from T1 ToneMatch Audio Engine Details