Difference between revisions of "Template:T1 ToneMatch® Audio Engine / Connections to Power Stands"
m |
m |
||
Line 2: | Line 2: | ||
Usage: | Usage: | ||
<pre> | <pre> | ||
− | {T1 ToneMatch® Audio Engine / Connections to Power Stands | + | {{T1 ToneMatch® Audio Engine / Connections to Power Stands |
|Applicable Model={{Model 1S}} (or {{Model II}} | |Applicable Model={{Model 1S}} (or {{Model II}} | ||
− | } | + | }} |
</pre> | </pre> | ||
</noinclude> | </noinclude> |
Revision as of 14:15, 29 November 2012
Usage:
{{T1 ToneMatch® Audio Engine / Connections to Power Stands |Applicable Model={{Model 1S}} (or {{Model II}} }}
The {{{Applicable Model}}} can accept two inputs.
This makes it easy for two performers to connect their own T1®s to a {{{Applicable Model}}} Power Stand.
ToneMatch® Input
The ToneMatch® connection is specifically designed for a T1 ToneMatch Audio Engine. The ToneMatch® cable is supplied with the T1 ToneMatch Audio Engine and uses a male Ethercon connector at both ends.
Analog Input
The Analog connection is a ¼ inch phone jack. You can use this for a the second T1® using the T1® Analog Master output (¼ inch phone jack).
This connection is made with a standard ¼ inch jack instrument cable. This can be Tip-Sleeve or Tip-Ring-Sleeve connectors.
Set Power Stand Analog Input Trim to 3 to have approximately the same level as you would have if you had connected with the ToneMatch® connection. You may have to adjust this, but 3 is a good place to start.
Note: A T1® connected to the the Analog input will require the optional T1 ToneMatch® Audio Engine power supply.