Difference between revisions of "T1 ToneMatch® Audio Engine / Connections to Model II"
m |
m |
||
Line 9: | Line 9: | ||
==== Analog Input==== | ==== Analog Input==== | ||
+ | <section begin=AnalogInput /> | ||
[[Image:Analog Input 3.png|300px|right|Model II/Model 1S analog input]] | [[Image:Analog Input 3.png|300px|right|Model II/Model 1S analog input]] | ||
The Analog connection is a ¼ inch phone jack. You can use this for a second T1® using the T1® Analog Master output (¼ inch phone jack). | The Analog connection is a ¼ inch phone jack. You can use this for a second T1® using the T1® Analog Master output (¼ inch phone jack). | ||
Line 15: | Line 16: | ||
Set Power Stand Analog Input Trim to '''3''' to have approximately the same level as you would have if you had connected with the {{ToneMatch}} connection. You may have to adjust this, but '''3''' is a good place to start. | Set Power Stand Analog Input Trim to '''3''' to have approximately the same level as you would have if you had connected with the {{ToneMatch}} connection. You may have to adjust this, but '''3''' is a good place to start. | ||
− | + | <section end=AnalogInput /> | |
Note: A T1® connected to the the Analog input will require the optional [[T1 ToneMatch® Audio Engine power supply]]. | Note: A T1® connected to the the Analog input will require the optional [[T1 ToneMatch® Audio Engine power supply]]. | ||
Revision as of 00:37, 16 March 2013
The L1 Model II can accept two inputs.
This makes it easy for two performers to connect their own T1®s to a L1® Model II Power Stand.
ToneMatch® Input
The ToneMatch® connection is specifically designed for a T1 ToneMatch Audio Engine. The ToneMatch® cable is supplied with the T1 ToneMatch Audio Engine and uses a male Ethercon connector at both ends.
Analog Input
The Analog connection is a ¼ inch phone jack. You can use this for a second T1® using the T1® Analog Master output (¼ inch phone jack).
This connection is made with a standard ¼ inch jack instrument cable. This can be Tip-Sleeve or Tip-Ring-Sleeve connectors.
Set Power Stand Analog Input Trim to 3 to have approximately the same level as you would have if you had connected with the ToneMatch® connection. You may have to adjust this, but 3 is a good place to start.
Note: A T1® connected to the the Analog input will require the optional T1 ToneMatch® Audio Engine power supply.