Difference between revisions of "T1 ToneMatch® Audio Engine / Connections to Model II"
m |
m |
||
Line 21: | Line 21: | ||
[[Image:T1x2IntoModelII.gif]] | [[Image:T1x2IntoModelII.gif]] | ||
+ | |||
+ | {{lst: T1 ToneMatch® Audio Engine / 1/4 inch Output Connections to L1® Family Members |Balanced}} | ||
---- | ---- |
Revision as of 10:46, 1 September 2014
The L1 Model II can accept two inputs.
This makes it easy for two performers to connect their own T1®s to a L1® Model II Power Stand.
ToneMatch® Input
The ToneMatch® connection is specifically designed for a T1 ToneMatch Audio Engine. The ToneMatch® cable is supplied with the T1 ToneMatch Audio Engine and uses a male Ethercon connector at both ends.
Analog Input
The Analog connection is a ¼ inch phone jack. You can use this for a second T1® using the T1® Analog Master output (¼ inch phone jack).
This connection is made with a standard ¼ inch jack instrument cable. This can be Tip-Sleeve or Tip-Ring-Sleeve connectors.
Set Power Stand Analog Input Trim to 3 to have approximately the same level as you would have if you had connected with the ToneMatch® connection. You may have to adjust this, but 3 is a good place to start.
Note: A T1® connected to the the Analog input will require the optional T1 ToneMatch® Audio Engine power supply.
Template:Lst: T1 ToneMatch® Audio Engine / 1/4 inch Output Connections to L1® Family Members