Difference between revisions of "Template:L1 Model II Analog Input Gain Staging"
m (→Analog input trim (volume, or gain) control) |
m |
||
Line 13: | Line 13: | ||
===== T4S/T8S ToneMatch Mixers ===== | ===== T4S/T8S ToneMatch Mixers ===== | ||
# Connect the {{{Device|source device}}} Main Output to the {{Model II}} Analog Input | # Connect the {{{Device|source device}}} Main Output to the {{Model II}} Analog Input | ||
− | # Set the Analog Input trim to 9 | + | # Set the Analog Input trim to 9:00 o'clock. Control the volume with the Master Volume on the ToneMatch mixer. <br>[[Image:Model II Analog Input Level Green.png|Model 1S Analog Input]] <br>If you set the input trim higher, you will have excessive line noise. |
# If the '''Signal/Clip''' indicator glows red, decrease the '''Trim''' level so that it glows only green or yellow.<!-- # While playing the source, increase the {{Model II}} '''Trim''' level so that the '''Signal/Clip''' indicator glows green or yellow. This will probably be around 9:00-11:00 o'clock --> | # If the '''Signal/Clip''' indicator glows red, decrease the '''Trim''' level so that it glows only green or yellow.<!-- # While playing the source, increase the {{Model II}} '''Trim''' level so that the '''Signal/Clip''' indicator glows green or yellow. This will probably be around 9:00-11:00 o'clock --> | ||
Revision as of 21:04, 24 November 2019
Contents
L1 Model II Analog Input
The Analog input is a 1/4 inch (6.3 mm) Tip-Ring-Sleeve balanced input jack.
Analog input trim (volume, or gain) control
Setting the trim level on the Model II Power Stand is a one-time step. Once you have matched the output of the ToneMatch mixer to the input of the L1 you don't need to adjust it again.
T4S/T8S ToneMatch Mixers
- Connect the source device Main Output to the L1 Model II Analog Input
- Set the Analog Input trim to 9:00 o'clock. Control the volume with the Master Volume on the ToneMatch mixer.
If you set the input trim higher, you will have excessive line noise. - If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.
For other mixers
- Set the Trim control on the power stand to the 0 (zero) position.
- Connect the source device Main Output to the L1 Model II Analog Input
- Adjust the volume of the source device Main Output to the reference or nominal output level.
- If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.