Difference between revisions of "T1 ToneMatch® Audio Engine / XLR Inputs Sensitivity"
m (formatting for inclusion) |
m (ST moved page T1 ToneMatch® Audio Engine / XLR Inputs Sensitivity to T1 ToneMatch® Audio Engine / XLR Inputs Sensitivity) |
||
(3 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
+ | <noinclude> | ||
=== XLR Inputs — No [[Pad]]s required === | === XLR Inputs — No [[Pad]]s required === | ||
+ | </noinclude> | ||
+ | <noinclude> | ||
+ | {{T1 icon}}</noinclude> | ||
− | |||
The T1® XLR inputs on channels 1-3 were designed to accept inputs from microphones up to normal line-level inputs without needing a switch or a [[Pad|pad]]. This is in unlike the {{Model I}} or {{Classic}}) Power Stand where a [[Pad|pad]] is recommended for line-level inputs. | The T1® XLR inputs on channels 1-3 were designed to accept inputs from microphones up to normal line-level inputs without needing a switch or a [[Pad|pad]]. This is in unlike the {{Model I}} or {{Classic}}) Power Stand where a [[Pad|pad]] is recommended for line-level inputs. | ||
Latest revision as of 04:09, 26 March 2017
XLR Inputs — No Pads required
The T1® XLR inputs on channels 1-3 were designed to accept inputs from microphones up to normal line-level inputs without needing a switch or a pad. This is in unlike the L1 Model I or L1 Classic) Power Stand where a pad is recommended for line-level inputs.
- The T1 ToneMatch® Audio Engine Channels 1, 2, 3 inputs will accept a wide range of signals. We have not encountered a normal use where someone needed a pad - even using +4dbU console outputs, which is as high as it gets.
— MikeZ-at-Bose[1]
- ↑ MikeZ-at-Bose talks about T1® XLR inputs