Difference between revisions of "Template:L1 Model II Analog Input Gain Staging"
m (→Analog input trim (volume, or gain) control) |
m (→Analog input trim (volume, or gain) control) |
||
Line 18: | Line 18: | ||
#* On digital consoles this may be marked as '''-18 dBFS<ref>[https://en.wikipedia.org/wiki/DBFS dBFS]</ref><ref>[http://avres.com/blog/dbu-vs-dbfs.html dBU vs dBFS]</ref>'''. The exact value (-18 dBFS to -20 dBFS) may vary depending your location<ref>[https://en.wikipedia.org/wiki/DBFS#Analog_levels dBFS Analog Levels]</ref>. | #* On digital consoles this may be marked as '''-18 dBFS<ref>[https://en.wikipedia.org/wiki/DBFS dBFS]</ref><ref>[http://avres.com/blog/dbu-vs-dbfs.html dBU vs dBFS]</ref>'''. The exact value (-18 dBFS to -20 dBFS) may vary depending your location<ref>[https://en.wikipedia.org/wiki/DBFS#Analog_levels dBFS Analog Levels]</ref>. | ||
#* Refer to the manual for the {{{Device|source device}}} for details. | #* Refer to the manual for the {{{Device|source device}}} for details. | ||
− | # While playing the source, increase the '''Trim''' level so that the '''Signal/Clip''' indicator glows green or yellow. This will probably be around 9:00-11:00 o'clock | + | # While playing the source, increase the {{Model II}} '''Trim''' level so that the '''Signal/Clip''' indicator glows green or yellow. This will probably be around 9:00-11:00 o'clock |
# If the '''Signal/Clip''' indicator glows red, decrease the '''Trim''' level so that it glows only green or yellow. | # If the '''Signal/Clip''' indicator glows red, decrease the '''Trim''' level so that it glows only green or yellow. | ||
Revision as of 11:15, 8 April 2019
L1 Model II Analog Input
The Analog input is a 1/4 inch (6.3 mm) Tip-Ring-Sleeve balanced input jack.
Analog input trim (volume, or gain) control
Setting the trim level on the Model II Power Stand is a one-time step. Once you have matched the output of the ToneMatch mixer to the input of the L1 you don't need to adjust it again.
- Set the Trim control on the power stand to the 0 (zero) position.
- Connect the source device Main Output to the L1 Model II Analog Input
- Adjust the volume of the source device Main Output to the reference or nominal output level.
- While playing the source, increase the L1 Model II Trim level so that the Signal/Clip indicator glows green or yellow. This will probably be around 9:00-11:00 o'clock
- If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.