Template:L1 Model II Analog Input Gain Staging
L1 Model II Analog Input
The Analog input is a 1/4 inch (6.3 mm) Tip-Ring-Sleeve balanced input jack.
Analog input trim (volume, or gain) control
Setting the trim level on the Model II Power Stand is a one-time step. Once you have matched the output of the ToneMatch mixer to the input of the L1 you don't need to adjust it again.
- Set the Trim control on the power stand to the 0 (zero) position.
- Connect the source device Main Output to the L1 Model II Analog Input
- For a T4S/T8S set the Analog Input trim to 9:00-10:00 o'clock. Control the volume with the Master Volume on the ToneMatch mixer.
If you set the input trim higher, you will have excessive line noise.
- For a T4S/T8S set the Analog Input trim to 9:00-10:00 o'clock. Control the volume with the Master Volume on the ToneMatch mixer.
For other mixers:
- Adjust the volume of the source device Main Output to the reference or nominal output level.
- If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.