Sennheiser EW IEM G4

From Bose Portable PA Encyclopedia
Revision as of 13:19, 31 May 2021 by ST (talk | contribs)
Jump to: navigation, search


Sennheiser EW IEM G4

EW IEM G4 Twin

Main Components

  • SR IEM G4 stereo transmitter
  • 2 EK IEM G4 stereo receiver
  • 2 IE 4 earphones

Why do I hear a Noise/Hiss in the IEM system?

Why do I hear a Noise/Hiss in the IEM system?

The most common hiss that is referred to is caused by RF interference. An important step in setting up a system is to tune the equipment properly to ensure that external RF signals are avoided and hence interference is avoided.

The other hiss that is sometimes noticed is the internal workings of the unit itself. The body back receiver has inherent noise from the components especially when there is a low input signal. This phenomenon is not unique to Sennheiser but occurs across all manufacturers.

This internal noise is made more apparent when in a very quiet environment (like a recording studio) or when more sensitive earbuds (such as custom in-ear molds). From a practical standpoint once you have audio through the IEM system it will overshadow the noise from the internal components and most people will not even realize the noise is there.

Source

Stereo to Split Mono

How can I get two (2) separate mono mixes out of one stereo transmitter?
  1. Plug your first mono mix into the left input port on the back of the SR IEM G4 stereo transmitter and then plug your second mono mix into the right side input.
  1. Make sure the transmitter is set to stereo mode
  2. Turn on your bodypack receiver and hit the "set" button to enter the menu list
  3. Find the "Mode" option, hit the set button, change the setting to "Focus", and hit the set button again to save it
  4. Scroll until you find "Exit" and hit set to leave the menu screen
  5. Now you are back on the main screen of the pack. from the main screen, you can now choose which mix you want to hear by panning left or right with the arrow keys. Hit the down arrow a few times until only mix #1 can be heard, or hit the up arrow a few times until only mix #2 can be heard. The arrows act as a crossfader between the two sources.
  6. There is no limit to how many receiver packs can tune in to these 2 mono mixes you are transmitting, so if you have additional packs just set them to the same frequency and repeat steps 3-6 above.
  7. Just be aware that there may be a small amount of bleed from one channel into the other during quiet passages.

Source