Difference between revisions of "External Subwoofers"
m (first ed) |
m (Active Loudspeakers) |
||
| Line 8: | Line 8: | ||
==== {{Model II nl}}==== | ==== {{Model II nl}}==== | ||
{{#lst:L1® Model II Power Stand / Bass Line Out|Bass Module Output}} | {{#lst:L1® Model II Power Stand / Bass Line Out|Bass Module Output}} | ||
| + | |||
| + | |||
| + | |||
| + | === Active (powered) Loudspeakers=== | ||
| + | Using powered loudspeakers with any of the {{L1}} systems is not supported. {{Bose}} does have the [[PackLite® power amplifier Model A1]] which can be used to power up to two {{B1}}s. This is connected through the Power Stand Bass Line Out (applies to {{Classic nl}}, {{Model I nl}}, {{Model II nl}}. | ||
| + | |||
| + | If you want to use a powered loudspeaker system, you can use the Power Stand Bass Line Out. Here are the relevant notes depending on which model of {{L1 nl}} you are using. | ||
| + | |||
| + | * [[PS1 Power Stand / Bass Line Out|Model I or Classic Bass Line Out]] | ||
| + | * [[L1® Model II Power Stand / Bass Line Out|Model II]] | ||
| + | |||
| + | |||
| + | You will probably use an external powered loudspeaker in the same way as you would connect and [[A1|PackLite®]] amp. | ||
| + | |||
| + | Please see [[PackLite® power amplifier Model A1]] for extensive notes that include ideas that can be applied to other systems. | ||
Revision as of 15:30, 19 December 2008
Contents
External Subs
Passive (unpowered) Loudspeakers
Using loudspeakers other than the B1 Bass Module with any of the L1 systems is not supported. However you can safely try your own external subs if the impedance is no lower then 4 ohms (typically a single 4 ohm loudspeaker or two 8 ohm loudspeakers in parallel). The output from the Power Stand is 250 watts RMS into 4 ohms. This applies to all models to date)
L1® Classic and L1® Model I
L1® Model II
Active (powered) Loudspeakers
Using powered loudspeakers with any of the L1 systems is not supported. Bose® does have the PackLite® power amplifier Model A1 which can be used to power up to two B1 Bass Modules. This is connected through the Power Stand Bass Line Out (applies to L1® Classic, L1® Model I, L1® Model II.
If you want to use a powered loudspeaker system, you can use the Power Stand Bass Line Out. Here are the relevant notes depending on which model of L1® you are using.
You will probably use an external powered loudspeaker in the same way as you would connect and PackLite® amp.
Please see PackLite® power amplifier Model A1 for extensive notes that include ideas that can be applied to other systems.