Difference between revisions of "External Subwoofers"
m (Active Loudspeakers) |
m (tightened text) |
||
| Line 8: | Line 8: | ||
==== {{Model II nl}}==== | ==== {{Model II nl}}==== | ||
{{#lst:L1® Model II Power Stand / Bass Line Out|Bass Module Output}} | {{#lst:L1® Model II Power Stand / Bass Line Out|Bass Module Output}} | ||
| − | |||
=== Active (powered) Loudspeakers=== | === Active (powered) Loudspeakers=== | ||
| − | Using powered loudspeakers with any of the {{L1}} systems is not supported. | + | Using powered loudspeakers with any of the {{L1 nl}} systems is not supported. The [[PackLite® power amplifier Model A1]] is part the {{l1 nl}} System. It can be used to power up to two {{B1}}s. This is connected to the Power Stand Bass Line Out (applies to {{Classic nl}}, {{Model I nl}}, {{Model II nl}}. |
| − | If you want to use a powered loudspeaker system, you can use the Power Stand Bass Line Out. Here are the | + | If you want to use a powered loudspeaker system, you can use the Power Stand Bass Line Out as the signal source. Here are notes specific to the {{L1 nl}} you are using. |
* [[PS1 Power Stand / Bass Line Out|Model I or Classic Bass Line Out]] | * [[PS1 Power Stand / Bass Line Out|Model I or Classic Bass Line Out]] | ||
| Line 20: | Line 19: | ||
| − | You will probably use an | + | You will probably use an powered loudspeaker in the same way as you would connect an [[A1|PackLite®]] amp. |
Please see [[PackLite® power amplifier Model A1]] for extensive notes that include ideas that can be applied to other systems. | Please see [[PackLite® power amplifier Model A1]] for extensive notes that include ideas that can be applied to other systems. | ||
Revision as of 00:22, 20 December 2008
Contents
External Subs
Passive (unpowered) Loudspeakers
Using loudspeakers other than the B1 Bass Module with any of the L1 systems is not supported. However you can safely try your own external subs if the impedance is no lower then 4 ohms (typically a single 4 ohm loudspeaker or two 8 ohm loudspeakers in parallel). The output from the Power Stand is 250 watts RMS into 4 ohms. This applies to all models to date)
L1® Classic and L1® Model I
L1® Model II
Active (powered) Loudspeakers
Using powered loudspeakers with any of the L1® systems is not supported. The PackLite® power amplifier Model A1 is part the L1® System. It can be used to power up to two B1 Bass Modules. This is connected to the Power Stand Bass Line Out (applies to L1® Classic, L1® Model I, L1® Model II.
If you want to use a powered loudspeaker system, you can use the Power Stand Bass Line Out as the signal source. Here are notes specific to the L1® you are using.
You will probably use an powered loudspeaker in the same way as you would connect an PackLite® amp.
Please see PackLite® power amplifier Model A1 for extensive notes that include ideas that can be applied to other systems.