View source for Mixer / Allan & Heath / MixWizard WZ3

<big>''' Allan Heath MixWizard WZ<sup>3</sup>'''</big>

== Summary ==
Simplest thing that could possibly work.

''' {{Use1/4}} '''

=== Wizard 16:2 Output Section  ===

[[Image:AllanHeathMixWizard162Output00.gif]]

=== Wizard 12:2 Output Section  ===

[[Image:AllanHeathMixWizard122Output00.gif]]


== Outputs ==

=== XLR Balanced +4 === 

{{TooHotForPS1}}

=== Notes From the MixWizard Manual ===
'''Matching the Console to Destination Equipment '''

This is an excerpt from page 23 of the [http://www.allen-heath.com/DL/w3ug_122-162_ap5331_3.pdf Allan-Heath Manual for the Wizard 3 Series Mixers]
''The console produces a standard XLR output level of +4dBu for a meter reading of ‘0’. It can produce a maximum of +26dBu which is more than is usually required and therefore gives you plenty of headroom. If you are connecting to a sensitive power amplifier it is advisable to turn down its input trim control if the normal console level is too high. Simply turning down the console output faders degrades the output stage noise performance and reduces the resolution of the fader movement. The output faders are best operated around ‘-10’ to ‘0’ for loudest average volume required. This allows additional headroom if you need it.''
	
The {{PS1}} XLR inputs are designed for microphone level inputs so the +4 dBu output from this mixer is too high for optimal operation - even with the trims levels set to 0. For best results use a [[Pad]] to more closely match the output of the Allen Heath mixer with the inputs of the {{PS1}}

=== &frac14; Inch with suitable output===
for PS1 Powerstand Channel 1 or 2 inputs

{{RunTROrTRSUnbalanced}}


Links:
* [http://www.allen-heath.com/DL/w3ug_122-162_ap5331_3.pdf Allan-Heath Manual for the Wizard 3 Series Mixers]



<!--
Wizard 16:2 Output Section

[[Image:AllanHeathMixWizard162Output00.gif]]

Wizard 12:2 Output Section

[[Image:AllanHeathMixWizard122Output00.gif]]


-->
'''AB OUT'''

This is an excerpt from page 14 of the [http://www.allen-heath.com/DL/w3ug_122-162_ap5331_3.pdf Allan-Heath Manual for the Wizard 3 Series Mixers]

''AB OUT A pair of impedance balanced TRS jacks can be configured to provide an additional LR mix or engineers monitor send. These operate at -2dBu line level. A front panel recessed ‘mode’ switch determines the source to the AB output. This may be set to follow the console monitor system and therefore feed an independent local stereo monitor or even engineers wedge speaker. When set to follow the LR mix, the factory default source is taken post LR fader.''

[[Image:AllanHeathMixWizard122Output01.gif]]

[[Image:AllanHeathMixWizard122Output02.gif]]




----
<references/>

[[category:Mixer]]