Mixer / Yamaha / MG8/2FX

From Bose Portable PA Encyclopedia
(Redirected from Mixer / Yamaha / MG10 / 2)
Jump to: navigation, search

Classic This information is applicable to the L1® Classic
L1 Model I This information is applicable to the L1 Model I

Yamaha MG8/2FX Mixer and MG10/2 Mixer

Summary

Simplest thing that could possibly work.

Use the ¼ inch phone jack (Tip-Sleeve) outputs to the PS1 Powerstand, Channels 1 or 2 if you want to use the presets and the Tone and Level Controls on the R1 Remote


Outputs

¼ Inch with suitable output

for PS1 Powerstand Channel 1 or 2 inputs

You can use TS (Tip Sleeve) unbalanced cables, or TRS (Tip Ring Sleeve) balanced cables, but since the ¼ inch phone connections at the Bose Classic and Model I Power Stand are unbalanced there is no particular benefit using balanced cables.

¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)

Tip-Sleeve to Tip-Sleeve

This should work fine.

¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced)

Tip-Ring-Sleeve to Tip-Sleeve

This should work fine.

¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)

Tip-Ring-Sleeve to Tip-Ring-Sleeve

This should also work, but likely no better than a simple ¼ Inch Tip-Sleeve to Tip-Sleeve cable. This is because the ¼ Inch input on the Bose System is Tip-Sleeve (unbalanced) anyway.


Links:

YamahaMG82Out.gif

Specifications for the MG10/2, MG82FX

OUTPUT CHARACTERISTICS MG8/2FX
Connection 	Actual
Source
Impedance 	For Use With
Nominal 	Output Level *1 	Connector
In Mixer
Nominal 	Max. before Clip
ST OUT [L, R] 	150 Ω 	10 kΩ Lines 	+4 dBu (1.23 V) 	+24 dBu (12.3 V) 	Phone Jack (TRS) *6
AUX SEND 	150 Ω 	10 kΩ Lines 	+4 dBu (1.23 V) 	+20 dBu (7.75 V) 	Phone Jack (TRS) *6
CH INSERT OUT (1 – 2) 	150 Ω 	10 kΩ Lines 	0 dBu (0.775 V) 	+20 dBu (7.75 V) 	Phone Jack (TRS) *5
2TR OUT [L, R] 	600 Ω 	10 kΩ Lines 	-10 dBV (245 mV) 	+10 dBV (2.45 V) 	RCA Pin Jack

More Notes