Difference between revisions of "T1 ToneMatch® Audio Engine / 1/4 inch Output Connections to L1® Family Members"
m (formatting and overview) |
m |
||
Line 1: | Line 1: | ||
− | Connecting from a {{T1}} ¼ inch jack to a {{Classic}}, {{Model I}} or {{Model II}} is simple. | + | Connecting from a {{T1}} ¼ inch jack (Master or Aux) to a {{Classic}}, {{Model I}} or {{Model II}} is simple. |
=== Overview === | === Overview === |
Revision as of 10:11, 28 April 2009
Connecting from a T1 ToneMatch Audio Engine ¼ inch jack (Master or Aux) to a L1 Classic, L1 Model I or L1 Model II is simple.
Contents
Overview
You can use TS (Tip Sleeve) unbalanced cables, OR TRS (Tip Ring Sleeve) balanced cables. If the cable uses ¼ inch jack plugs and the ends are the same, then the cable should be fine.
OR
Classic or Model I
¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)
This should work fine.
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)
Since the ¼ inch phone connections at the Bose Classic and Model I Power Stand are unbalanced there is no particular benefit using balanced cables but there is no harm.
Model II
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced)
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)
This should also work, and provided better noise rejection over greater distances than the unbalanced connection above.