T1 ToneMatch® Audio Engine / Digital Delay for Second L1®

Here are some notes on how to use your T1™ to drive a main L1™ at the front of the house and a second L1™ farther back. The goal is to provide sound in a long room, in this case approximately 50 feet wide by 250 feet long.

Terms

• Main L1™ is the one at the front of the house.
• Secondary L1™ is the one farther back.

Connections

T1™ Inputs

•   1  Microphone
•   2 Microphone / Instrument or Mixer
•   3 Used for Digital Delay processing
• 4/5 USB input from Computer

T1™ Outputs

• Tonemate™ (Ethercon Connection) goes to the Main L1&trade.
• Main ¼ inch output goes to Channel 3 input.
• Aux ¼ inch output goes to Secondary L1™ Analog Input

Turn down the Master Volume while making the following connections

Ordinary connections

Connect inputs for Channels 1, 2 and 4/5 in any way you like. Ensure that the setting for Aux is Mute for all.

Channel 3 – Turn level down, Ch 3 Mute

We are setting the Level to zero and we will not change this while using Channel 3 for Digital Delay processing. We are setting the Mute as an additional precaution.

Settings for Channel 3

• Turn on Channel 3 CH Edit
• Turn the main Selector to Digital Delay

Digital Delay – Mix and Time

Set the Mix to 100%. This way we are outputting the delayed signal only.

We are setting the Time to 100ms to start. We will fine tune the time setting by ear later.

Digital Delay – Fdbk (feedback)

• Press the third button to switch from Time to Fdbck.
• Rotate the button to set the Fdbk to 0%

Channel 3 Aux

• While still working with the CH 3 Edit lit turn the main selector to Aux.
• Set the Level to 100%

Aux – Tap Setting

• Press the Tap button and set it to Pre: With EQ & FX

Main Out (¼ inch) to Channel 3 Input